FS FORCE

Posted: **Mon Mar 14, 2016 11:03 pm**

Iris Dragonfly yoke / FSX.

AP follow appears to work. The 'yoke offset' issue occurs as described and is usually small, fixed with a yoke reset' button I have mapped. BUT often when I switch the AP off I have a very large forward trim (e.g. -99) and the aircraft immediately nose-dives. This happens maybe 50% of the time. It happens with the default Cessna 172 as well as with my addon aircraft (Aerosoft Twin Otter, BN-2 Islander). If I leave the AP follow off I don't get the problem.

Posted: **Tue Mar 15, 2016 2:46 am**

Are you using FSUIPC for your elevator & aileron assignments? If so, that could be the cause of this issue. If you want to use the AP Follow feature, aileron, elevator and all trim commands/buttons/wheels need to be programmed via the P3D Settings-Controls screen.

Posted: **Tue Mar 15, 2016 6:15 pm**

RussDirks wrote:Are you using FSUIPC for your elevator & aileron assignments?

Yes, I was doing this. I have changed the elevator axis to be controlled by FSX and that seems to have sorted the problem.

Thanks.

FS FORCE

AP Follow often causes loss of control on disconnect

AP Follow often causes loss of control on disconnect

Re: AP Follow often causes loss of control on disconnect

Re: AP Follow often causes loss of control on disconnect